SPECIFICATION |
Printing method |
Line Thermal dot printing |
Printing width |
48 mm (384 dots/line) |
Dot pitch |
8 dots/mm |
Printing speed |
Approx. 11 lines/sec (Max.) |
Number of Columns |
Font A: 32 col.
Font B: 42 col. |
Font size |
Font A: 12 x 24
Font B: 9 x 24 |
Emulation |
ESC/POS |
Bar-code type |
UPC-A/E, JAN (EAN), ITF, CODABAR, CODE39, CODE128 |
Line spacing |
4.23 mm (1/6 inches) |
Printing paper |
Thermal roll paper: 58mm x 83 O(max)mm Thickness: 60 - 75 μm
Thermal label paper: 58mm x 83 O(max)mm Thickness:150 μ
Label width: 56mm (Max)
Label length: 25mm/pc (Min) |
Interface |
Serial (RS-232C) or Parallel (Centronics) |
Input buffer |
2K bytes |
Battery |
Battery pack |
6HR-AAU-CBM ( 7.2 VDC, 1650 mA/h)NiMH (pack of 6AA dry cells, connectable to charge via connector) |
Charging time |
Aprox. 6 hours (to full charge) |
Charging monitor |
Power lamp (red) lit in charging mode, goes off when fully charged. |
Recharging cycles |
Over 300 cylcles (at room temperature). Built-in charger. |
Charger power supply |
27AD. The printer can be powered while the batteries are charging (floating). |
Discharge control |
Low voltage alarm=6.5V. discharge termination voltage=6.0V, monitored by signal output and power lamp. (green).
|
No. of printable lines |
Approx. 20,000 lines and more (continuous sliding print of ANK characters at print tone level
2, at room temperature). |
Power Save
&
Auto Power Off |
To save battery consumption, theprinter automatically enters the power save mode if it receives no print data, or not operated, for approx. 10 minutes. If the
same inactive state continues for another 10 minutes, the auto power off feature automatically turns the printer off. (The timer intervals can be set with a DIP
switch.)
To turn the printer on again, temporarily set the power switch to OFF, then set it back to ON. All data will initialize when the printer repowers. The power save
and auto power off features are left disabled when the printer is powered from the AC adaptor.
|
AC adaptor |
Rated input: 100~240V, 50/60 Hz. 40VA
Rated output: 7.2V DC, 2A
|
Weight |
Approx. 600g |
Power consumption |
At non-printing: Approx. 2W
At printing: Approx. 15W (approx. 20W at maximum) |
External dimensions |
106 (W) x 183 (D) x 126 (H) mm |